CONTACT US

conveyor belt
Anti-tear Conveyor Belt Manufacturer

Cleaner Manufacturer & Supplier

In the continuously booming industry of conveyor belt, many manufacturers are focusing on extending production capacity without exploring their own core technology. ELEPHANT GROUP stress on our technological research as much as on our annually increasing market share.

Please Contact Us: elephantbelt@gmail.com         elephantbelt1
 

 

Primary Cleaner
primary cleaner
  • Characteristics:
  • The primary cleaner should be installed below the center line of the pulley. It is the new-generation product of cleaner. The blade, made of macromolecular material, is abrasive resistant, anti-corrosion, breaking resistant, hydrolysis resistant, belt-friendly. The cleaner has a tension controller, which ensure the tight contact of the cleaner with belt so that it can scrap thoroughly.
  • Suitable range:
  • 1. belt width:500-2200mm
    2. belt speed:≤3.5m/s
    3. material humidity:≤15%
    4. temperature:-40℃~90℃
Secondary Cleaner
SECONDARY CLEANER
  • Characteristics:
  • The secondary cleaner should be installed at the beginning of the returning trip of the conveyor belt, below the pulley. Usually used to cooperate with the primary cleaner. The spring device can automatically tighten the cleaner with the conveyor belt so that it can scrape effectively without hurting the belt.
  • Suitable range :
  • 1.belt width:500~2000(mm)
    2.belt speed:≤3.5(m/s)
    3.material humidity:≤15%
    4.temperature:-40-90℃
    Secondary Cleaner with Metal Blade
    secondary cleaner with metal
  • Characteristics:
  • The secondary cleaner with metal blade should be installed at the beginning of the returning trip of the conveyor belt, below the pulley. The structure of it has multiple design of buffering, including the spring device, rubber cushion, and polyurethane blade body. The buffering design can moderate the impact with the belt fasteners without hurting the belt.
  • Suitable range :
  • 1.belt width:650~2000(mm)
    2.suitable with belt spliced by fastener and vulcanizing.
    3.suitable with poor weather condition.

    Secondary V-Plow
    SECONDARY V-PLOW
  • Characteristics:
  • The V-plow is designed to clean the inside(clean side) of the return belt. The blade is made of polyurethane, therefore it is abrasion resistant, corrosion resistant, belt friendly. Its structure enables it to adjust height automatically, and easily cleaned and repaired.
  • Suitable range:
  • 1.belt width:500~2000(mm)
    2.belt speed:≤3.5(m/s)
    3.material humidity:≤15%
    4.temperature:-40-90℃
    Brush-Type Cleaner
    BRUSH-TYPE CLEANER
  • Motor-controlled cleaner
  • The motor-controlled brush-type cleaner is a secondary cleaner, usually sued as a third cleaner below the return belt in order to clear the sticky material. Brush tip gently sweep the belt in the opposite direction of the belt running direction, therefore the tiny or sticky material could be thoroughly cleaned up.
  • Motor-free cleaner
  • The motor-free brush-type cleaner is passive cleaner with a very simple structure. The brush part is driven by a passive cylinder rotate by the running belt. It requires no electricity or controlling device. Brush tip gently sweep the belt in the opposite direction of the belt running direction, therefore the tiny or sticky material could be thoroughly cleaned up.
    1. The material we use to make the bristle is usually highly elastic, abrasion resistant nylon thread, with diameter of φ2.0mm.
    2.It is fully motivated by the friction with the conveyor belt, and requires no power station or controlling device.
    3.The brush sweeps the opposite direction as the belt runs.
    Copyright © http://www.elephantconveyorbelt.com